OPERATION OF MULTIRAE PLUS
2 - 10
2.4 Operation
The MultiRAE PLUS Multi-gas Monitor offers three
different user modes of operation:
Text
mode,
Display
mode, and
Programming
mode (default mode setting).
The
text
mode is the simplest mode of operation. The
monitor will display the sensor name after the monitor is
turned on. The user can press the
[MODE]
key to see the
instantaneous gas concentration reading, battery voltage or
enter the PC communication menu. The user can get into
the calibration mode from text mode to do calibrations, but
cannot change most of the parameters.
In the
display
mode, the MultiRAE PLUS Multi-gas
Monitor is able to display all the information in the text
mode. In addition, the following information is also
available by pressing the
[MODE]
key: peak, minimum,
STEL, TWA, run time in hours and minutes, temperature in
degree C, datalog mode (or enable / disable datalogging
operation in manual datalog mode), LEL/VOC gas names,
printing and communication with a PC options. The user
cannot get into the calibration mode from display mode, so
the user cannot do calibration and cannot change any of the
parameters.
In the
programming
mode, which is the default setting, the
user can perform all of the functions of the display mode. In
addition, the user can get into calibration mode, perform
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
