PROGRAMMING OF MULTIRAE
4 - 5
4.3 Entering into Programming Menu
1. Turn on the MultiRAE PLUS monitor (refer to Section
2.3 for the power on sequence).
2. Press and hold down both
[MODE]
and
[N/-]
keys
for
three seconds to enter programming mode. Note: This
is to prevent a user from entering the programming mode
by accident.
3. If the security level is 0 or 2, after holding down two
keys for 3 seconds, the monitor should enter the
programming mode and the first menu item “Calibrate
Monitor?” will be displayed.
4. If the security level is 1, or user mode is text mode, after
holding down the two keys for three seconds, the display
will show “Enter Password = 0000” with the left-most
digit flashing. The user should enter a password starting
from this flashing digit.
Note 1:
Prior to factory shipment, the MultiRAE PLUS
monitor was installed with “0000” as the default
password.
Note 2:
For added security, “0000” is always displayed
instead of the actual password at this step.
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
