PROGRAMMING OF MULTIRAE
4 - 33
4.7.4 Change Real Time Clock
The MultiRAE monitor is equipped with a real time clock.
The user can enter the correct date and time into the real
time clock in the programming mode.
1. The fifth sub-menu item in Table 4.6 is “Change Real
Time Clock?”
2. Press
[Y/+]
key, the display shows both the current date
and time: “Date = mm / dd” and “Time = hh : mm” with
the left most digit of the date flashing.
3. To modify this value, use the
[Y/+]
or
[N/-]
key to change
the digit value and press the
[MODE]
key momentarily to
advance to the next digit. The flashing digit will move on
to next digit to its right. Repeat this process until the
new date and time values are entered. Press and hold the
[MODE]
key for 1 second to exit data entry mode. If
there is any change to the existing value, the display
shows “Save?” Press the
[Y/+]
key to accept the new
value and move to next sub-menu. Press the
[N/-]
key to
discard the changes and move to next sub-menu.
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
