COMPUTER INTERFACE FOR MULTIRAE PLUS
5 - 4
5.2 Connect MultiRAE PLUS to PC
The basic kit of a MultiRAE PLUS datalogging monitor
includes a serial interface cable. Connect the DB-9
connector side of the cable to the serial port of the PC, and
connect another side of the cable to the MultiRAE PLUS
monitor.
Turn on the power to the MultiRAE PLUS monitor. Press
the
[MODE]
key several times until the LCD shows
“Communicate with PC?” Press the
[Y/+]
key and the display
shows “Monitor will Pause, OK?” Press
[Y/+]
key to
confirm and the display shows “Ready...” to indicate that the
MultiRAE PLUS monitor is ready for communication with
PC. During the communication session, the PC will directly
control the MultiRAE PLUS monitor through the serial link.
There is no need for users to press any key on the MultiRAE
PLUS monitor during the communication session.
If no data transfer has occurred within one minute, the
MultiRAE PLUS monitor will return to instantaneous
reading display.
Note: Do not connect to the parallel port of the PC by
mistake. The parallel port is usually a 25 pin
female D
connector
on the back of the PC, the serial port is usually a
25 or 9 pin
male D connector
. If the serial port on the PC
is a 25 pin connector, the user needs to use a 25 pin to 9 pin
adapter in order to accept the serial cable.
5.3 Start ProRAE-Suite Software
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
