UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1
Page: 796/970
Refresh - Refresh the data on the screen with the present state of the data in the switch.
11.2.3.3.6.
Configuring OSPF Interface
Selection Criteria
Slot/Port - Select the interface for which data is to be displayed or configured.
Configurable Data
OSPF Admin Mode* - You may select enable or disable from the pulldown menu. The
default value is 'disable.' You can configure OSPF parameters without enabling OSPF
Admin Mode, but they will have no effect until you enable Admin Mode. The following
information will be displayed only if the Admin Mode is enabled: State, Designated Router,
Backup Designated Router, Number of Link Events, LSA Ack Interval, and Metric Cost.
For OSPF to be fully functional, you must enter a valid IP Address and Subnet Mask via
the Interface IP Configuration page or through the CLI command: config ip interface
network .
*NOTE: once OSPF is initialized on the router, it will remain initialized until the
router is reset.
OSPF Area ID - Enter the 32 bit integer in dotted decimal format that uniquely identifies
the OSPF area to which the selected router interface connects. If you assign an Area ID
which does not exist, the area will be created with default values.
Router Priority - Enter the OSPF priority for the selected interface. The priority of an
interface is specified as an integer from 0 to 255. The default is 1, which is the highest
router priority. A value of '0' indicates that the router is not eligible to become the
designated router on this network
