UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1
Page: 56/970
Values
ipaddr This parameter is a valid IP address, made up of four decimal bytes ranging from 0 to
255. The default for all IP parameters consists of zeros (that is, 0.0.0.0). The interface IP
address of 0.0.0.0 is invalid.
macaddr The MAC address format is six hexadecimal numbers separated by colons, for
example 00:06:29:32:81:40.
areaid Area IDs may be entered in dotted-decimal notation (for example, 0.0.0.1). An area ID
of 0.0.0.0 is reserved for the backbone. Area IDs have the same form as IP addresses, but are
distinct from IP addresses. The IP network number of the sub-netted network may be used for
the area ID.
routerid The value of <router id> must be entered in 4-digit dotted-decimal notation (for
example, 0.0.0.1). A router ID of 0.0.0.0 is invalid.
slot/port This parameter denotes a valid slot number, and a valid port number. For example,
0/1 represents unit number 1, slot number 0 and port number 1. The <slot/port> field is
composed of a valid slot number and a valid port number separated by a forward slash (/).
logical slot/port This parameter denotes a logical slot number, and logical port number
assigned. This is applicable in the case of a port-channel (LAG). The operator can use the
logical slot number, and the logical port number to configure the port-channel.
Conventions
Network addresses are used to define a link to a remote host, workstation, or network.
Network addresses are shown using the following syntax:
Table 5-1. Network Address Syntax
Address Type
Format
Range
IPAddr
A.B.C.D
0.0.0.0 to 255.255.255.255
MacAddr
YY:YY:YY:YY:YY:YY
hexidecimal digit pairs
Double quotation marks such as "System Name with Spaces" set off user defined strings.
If the operator wishes to use spaces as part of a name parameter then it must be enclosed in
double quotation marks.
Empty strings (““) are not valid user defined strings. Command completion finishes
spelling the command when enough letters of a command are typed to uniquely identify the
command word. The command may be executed by typing <enter> (command abbreviation) or
