22
SunTouch
®
Control System Installation and User’s Guide
Advanced Menu (8/14): Temp Units F° / C° (Fahrenheit/Celsius)
The temperature settings for the water, solar and air can be displayed in either Fahrenheit or Celsius on the
Main screen.
FAHRENHEIT/CELSIUS
To change the temperature units:
Menu button:
Select the
Advanced 8/14
menu.
Right button:
Select the
TEMP UNITS (Fahrenheit/Celsius)
setting.
Up/Down buttons:
Select either Fahrenheit or Celsius units for temperature settings
displayed on the Main screen.
Left button:
Press the Left button to return to the main status screen.
Advanced Menu (8/14): Pool/Spa Delays
The pool and spa delays feature allows you to assign a delay function to the following equipment.
•
Heater Cool-Down Delay Cancel:
Shuts Filter Pump off immediately.
Some heaters require a cool-down cycle before being switched off. This can be setup to run the
filter pump an additional ten minutes to dissipate residual heat built up inside the heater combustion
chamber. You can also cancel the delay feature. For information about using the cancel delay
feature, refer to “Delay Cancel” on page 16.
•
Valve Delay:
If the heater is operating, and the VALVE DELAY feature is enabled for valves, this
allows the heater to cool down (heater cool-down), then when the pump is switched off, only the
heater will turn off, then the filter pump will automatically switch off after 10 minutes to allow the
heater to cool down. Pentair Aquatic System heaters do not require a cool down time. To override
the “heater cool-down,” press the filter pump button again to switch off the pump.
•
2-Speed Filter Pump five (5) minute START on HIGH SPEED Delay Cancel:
Shifts pump to
low speed.
•
Automatic Pool Cleaner START Delay:
Starts Cleaner Pump immediately, without normal delay in
which the filter pump first runs for five (5) minutes.
•
Automatic Pool Cleaner SOLAR Delay:
Allows Cleaner Pump to run even though the solar delay
has shut it off for five (5) minutes.
HEATER and VALVE DELAYS
To assign the heater delay feature:
Menu button:
Select the
Advanced 8/14
menu.
Right button:
Select the HEATER DELAY setting.
Up/Down buttons:
Select
Yes
to enable or
No
to disable delays for the pool and spa
heater circuits.
Left button:
Press the Left button to return to the main status screen.
Heater Delay
Enabled: Yes
Main Menu 8/14
Advanced
Menu button:
Select the
Advanced 8/14
menu.
Right button:
Select the VALVE DELAY setting.
Up/Down buttons:
Select
Yes
to enable or
No
to disable delays for the pool and spa
heater circuits.
Left button:
Press the Left button to return to the main status screen.
Heater Delay
Enabled: Yes
Main Menu 8/14
Advanced
Temp Units
[FAHRENHEIT ]
Main Menu 8/14
Advanced
To assign the valve delay feature:
