81
SunTouch
®
Control System Installation and User’s Guide
Commercial Application using ESO3 and SunTouch
®
Control System
(Single Body System)
Using a Emergency Shut-Off Switch (ESO3), circuit board, and a spring wound timer switch
(Intermatic
®
Transformer equivalent), a SunTouch
®
Control System single body system (P/N 520859)
can be configured for a commercial application. A typical configuration, using a single speed pump is
shown in the “Commercial Application Connection Diagram” below. As shown, the commercial spa
jet pump is controlled by the spring wound timer switch and AUX 1 (Jet pump) is programmed by
SunTouch to operate from 5:00 AM to 12:00 AM. When the Emergency Shut-Off Switch is pressed, both
relays will disengage. If the pool or spa light is controlled by AUX 2, the light will remain operational.
VA
LVE A
CTU
AT
ORS
INT
AKE
RETURN
SOLAR
AUX 3
PUMP
AUX 2
AUX 1
VL
V A
VL
V B
VL
V C
ONL
Y
SOLAR
CLNR
GAS
HEATER
RESET
CR2032
+3V
J12
A
B
C
D
E
F
SHUT OFF
+ -
A
B
C
D
E
F
J13
Commercial Spa Jet Pump
(For IntelliFlo® VS+SVRS/VSF+SVRS,
Pump disable PRIMING feature)
WhisperFlo® Filter Pump
(or IntelliFlo VS-SVRS/VSF-SVRS)
Spring Wound
Timer Switch (DPST)
ESO Module
ESO Emergency
Shut Off Switch
IntelliFlo® VS+SVRS
/VSF-SVRS
Jet Pump
Relay
IntelliFlo® VS+SVRS
/VSF-SVRS
Filter Pump
Relay
LINE VOLTAGE
LINE VOLTAGE
LINE VOLTAGE
LINE VOLTAGE
AUX 2
(POOL or
SPA Light)
AUX (Filter Pump)
AUX 1
Pool or Spa Light
520106
520106
P/N 520859
SunTouch® Control
System Motherboard
SunTouch
®
Control System
for commercial appliction with
IntelliFlo VS+SVRS
and IntelliFlo
®
VSF+SVRS Pump
IntelliFlo VS+SVRS and
VSF+SVRS Filter Pump is
controller by SunTouch Control
System Internal time clock AUX
1 (VS+SVRS Jet Pump) in this
applicatin will be
programmed to operate during the
hours of operation (e.g. 5:00 AM -
12:00 AM).
When Emergency Switch is
pressed, both relays disengaged.
If the pool or spa
light are controlled by AUX 2
light will remain on. For use with
single speed pumps or IntelliFlo
VS+SVRS pump.
Note: Spring wound timer must be a DPST
switch. Both legs of
power must be turned OFF. For IntelliFlo
®
VS+SVRS/VSF+SVRS Pump,
disable “Priming” feature.
Required Parts:
1. P/N 520859
SunTouch Control
System Single Body
2. P/N ES03
Emergency Shut Off
3. Spring Timer (P/N
FF4 15M, FF4 30M,
FF4 60M)
Note: Spring wound
timer (DPS) for
booster jet pump must
be rated for proper
amperage.