37
SunTouch
®
Control System Installation and User’s Guide
IntelliChlor
®
Salt Chlorine Generator Menu (13/14): Status and Error Messages
If an error alert, or warning is detected by the IntelliChlor
®
Salt Chlorine Generator (SCG), the error message
will be displayed on the SunTouch Control System control panel screen. All status and error messages can
be viewed from the IntelliChlor (SCG) menu. For troubleshooting information, refer to the IntelliChlor
Electronic Chlorine Generator User’s Guide (P/N 520589).
To view the IntelliChlor (SCG) status and error messages:
Menu button:
Select the “IntelliChlor” menu.
Right button:
Press the button until the Salt status screen is displayed.
Displays the current IntelliChlor (SCG) chlorination system status.
Left/Right button:
Press the Left or Right button to return to the main status screen.
IntelliChlor status and error messages:
SALT LEVEL:
Displays the current salt level. Values from 0 to 12750 ppm in 50 ppm
increments.
IntelliChlor Status and Error messages:
SUPER CHLORINATE:
The IntelliChlor (SCG) is in Super Chlorination mode. For
information
COM LINK ERROR:
Check cable from the IntelliChlor (SCG) to the SunTouch Control
System motherboard.
Check FLOW/PCB:
Check the IntelliChlor (SCG) controller. Refer to IntelliChlor
(SCG) User’s Guide Troubleshooting information.
LOW SALT:
Add salt to pool water. The water salt level is between 2500 ppm and
2950 ppm. The IntelliChlor (SCG) will continue to produce chlorine at a reduced
level.
VERY LOW SALT:
Not enough salt in pool. The water salt level has fallen below 2500
parts per million (ppm). The IntelliChlor (SCG) cell will not produce chlorine until
additional salt is added manually.
HIGH CURRENT:
Check the IntelliChlor (SCG) cell. Refer to IntelliChlor (SCG)
User’s Guide troubleshooting information.
CLEAN CELL!!:
Cell has calcium build up and requires cleaning. Refer to IntelliChlor
(SCG) User’s Guide for cleaning instructions.
LOW VOLTAGE:
Check IntelliChlor (SCG) cell. Refer to IntelliChlor (SCG) User’s
Guide troubleshooting information.
OK - NO ERRORS:
IntelliChlor (SCG) is in normal operating mode.
About Super Chlorination:
The Super Chlorination feature is used to introduce large amounts of chlorine
into the pool water if there has been heavy rain fall, many bathers in the pool, cloudy water conditions, etc.
When Super Chlorination is enabled, the system will switch on the filter pump, set the pool/spa valves to the
correct position, and set the IntelliChlor (SCG) to maximum output. This process continues for 24 hours.
At the end of the Super Chlorination process, the system will return to normal operation. It is possible to
manually stop the Super Chlorination process and switch off the filter pump in the “Circuit On/Off” menu
(see page 13). When the filter pump is switched on again, the Super Chlorine process will resume for the
duration of time that is left.
Main Menu 13/14
IntelliChlor
Salt: 3200 ppm
[OK - NO ERRORS]