18
SunTouch
®
Control System Installation and User’s Guide
Schedules Menu (4/14)
(Continued)
Schedule your Spa or Pool
You can set a daily start and stop time to switch the filter pump on and rotate the pool or spa valves into
the “Spa” or “Pool” position. The heater will automatically heat the spa or pool water up to the set point
temperature as set in the “Heat” menu (see page 14). If the pool has a separate jet pump or blower controlled
by AUX 1 and/or AUX 2 , these need to be scheduled separately. You can also program when to filter and heat
your pool, and switch light or auxiliary circuits on or off.
You can create schedules to automatically run equipment like pool filtration or lights. Any circuit can be set
to switch on and off on every day of the week. When a relay is switched on manually, it remains on until
you either switch it off manually, or the next time the relay is scheduled to be switched off. For example, if
the filter pump or any circuit is scheduled to run from 9:00 AM to 4:00 PM and the programmed schedule
is turned OFF at 1:00 PM and then turned on at 1:10 PM, the circuit will turn OFF at its programmed OFF
time of 4:00 PM. But if the circuit is turned on after 4:00 PM, the factory set Egg Timer of 12 hours is now
engaged. So if the circuit was turned on at 6:00 PM that circuit will turn off at 6:00 AM (12 hours later). If
the circuit was turned ON at 5:00 PM and because a programmed OFF time had been set to turn off at 4:00
PM, the circuit would operate for 11 hours. A spa or pool program can be overridden using the Spa button (Up
arrow) or switch the Circuit On/Off pool filter pump on in the Circuit On/Off menu (see page 13).
Edit an existing program
1. Press the Menu button until
Schedules 4/14
is displayed then press the
Right button
.
2. Press the
Up/Down button
to scroll through the circuits with their assigned programs.
3. Press the
Right button
to move to the first digit of the program number for the circuit. For example
(
2
/4), two is the second program of four assigned programs.
4. Press the
Up/Down button
to select the desired program number.
5. Press the
Right button
to move to the mode setting.
6. Press the
Up/Down button
until Edit is displayed. To edit the start and stop time for the circuit,
press the
Right button
to move to the Start setting.
Delete a program
1. Press the Menu button until
Schedules 4/14
is displayed then press the
Right button
.
2. Press the
Up/Down button
to scroll through the circuits with their assigned programs.
3. Press the
Right button
to move to the first digit of the program number for the circuit. For example
(
3
/4), one is the third program of four assigned programs.
4. Press the
Up/Down button
to select the desired program number.
5. Press the
Right button
to move to the mode setting. Press the
Up/Down button
until “Del” is
displayed.
6. Press the
Right button
to delete the program 1. The program counter now displays (3/4). If you
want to delete the other three programs, repeat steps 3 through 6.
