6
SunTouch
®
Control System Installation and User’s Guide
Set Water Temp
Solar Only [Pool/Spa]
System Mode
Temp: [40˚F - 104˚F or (4˚C - 40˚C)
Auto, Solar OFF, Solar ON
System Control
Time Set: Hour/Minutes - AM/PM
Time Set
Heat Start Temp Diff
Temp Diff: [3˚ - 9˚F]
Temp Diff: [2˚ - 5˚F]
Heat StopTemp Diff
Enabled: No [Yes]
Cooling
Adjusting the water temperature setting (Solar Only mode)
If you have already set the pool and spa water temperature in the “SET WATER TEMP” menu and you
need to adjust the water set point temperature, use the
(-) TEMP
or
(+) TEMP)
buttons to adjust the
water temperature.
•
Press the
(-) TEMP
or
(+) TEMP)
button to lower or raise the set temperature to the desired level.
The water temperature can be adjusted from 40° F to 104° F (4° C to 40° C). When solar heat is
available SOL ON is displayed on the lower display line. SOL OFF is displayed if solar heat is not
available (OFF). Degree units are displayed in either Fahrenheit or Celsius (see page 22).
Note: To
display the air temperature setting on the main screen, verify that the air sensor is enabled in the
Main menu, see “Advanced Menu,” on page 24.
Solar Only Menus
The following Main Menu features are available when the SunTouch
®
Control System is configured in
“Solar Only” mode. The main menu features are as follows:
Set Water Temperature
To set the water temperature:
Menu button:
The Set Water Temp menu is displayed.
Up/Down button:
Adjust to the desired set temperature from 40° F to 104° F or
(4° C to 40° C). This allows the solar system to heat the water up to set point
temperature. After the set point temperature is reached, the solar system is
automatically switched off.
To determine your optimum water temperature setting,
set the “Set Temperature” settings to 100° F and observe the water temperature over a
period of a few days. When the maximum desired temperature of the pool is reached,
set the temperature again. Once this setting is identified, it will not be necessary to
change the set temperature again
.
Left button:
Press the Left button to return to the main status screen.
Menu button:
Press the Menu button to enter the “System Mode” menu. From this
menu you can change the system from “Solar Only” mode to “Pool/Spa” mode.
Solar Only Menus
The Solar Only Mode menus are shown below:
Set Water Temp
Temp: 81°F
WATER 71°F / 91°F
11: 51AM SOL ON
▼
Set
temperature
Lower water set
point temperature
Actual
temperature
Solar heat is
available
AIR 59°F
11: 51 AM
Raise water set
point temperature
Current air temperature (displays if optional
air sensor is enabled in the Solar Only menu)
Enabled: No [Yes]
Solar Freeze
Enabled: No [Yes]
Cleaner Freeze
Enabled: No [Yes]
Air Sensor
Sensor installed for
Cool Start Temp Diff
Temp Diff: [3˚ - 9˚F]
Temp Diff: [2˚ - 5˚F]
Cool StopTemp Diff
freeze protection.