15
SunTouch
®
Control System Installation and User’s Guide
Heat Menu (2/14)
(Continued)
Spa Temperature and Heat Source
To set the SPA temperature and switch the HEATER ON or OFF:
Menu > Right arrow button:
Select the
Heat
settings.
Right/Left arrow button:
Select the
SPA
temperature setting.
Up/Down arrow button:
Adjust to the desired spa set point temperature
(from 40° F to 104° F or 4° C to 40° C).
Right arrow button:
Access the
POOL HEAT
source setting.
Up/Down arrow button:
Select the heat source options:
OFF, HEATER, SOLAR
PREFERRED
or
SOLAR
.
Left arrow button:
Press the Left button to return to the main status screen.
HI-TEMP (Up Arrow button)
For SunTouch
®
Control System single body systems (pool only or spa only, see page 36), the
HI-TEMP (UP
arrow button)
is used to switch the heater (regardless of the Heat menu setting) and filter pump on and off.
Typically this circuit is used with the “Manual Heat” feature (see below) for on-demand spa water heat. The
heat temperature settings are displayed on the main screen. The heater is active when the set temperature is
higher than the water temperature. The heater will switch off when the water temperature rises above the set
temperature.
LO-TEMP (Spa) Menu Operation
The LO-TEMP on and off control is made from the Heat menu setting. For SunTouch
®
Control System
single body systems (pool only or spa only, see page 36), the LO-TEMP menu setting is used to switch on
and off the heat source and filter pump. A heat selection must be selected in the Heat menu before the heater
is activated. The “Manual Heat” setting does not function with the LO-TEMP circuit. The heater is active
when the set temperature is higher than the water temperature. The heater will switch off when the water
temperature rises above the set temperature.
MANUAL HEAT (Off/On)
By default, the spa Manual Heat feature is always set to “ON.” This allows the spa to begin to heat whenever
the
SPA,
Up arrow button
is pressed, regardless of the heat source setting in the Heat menu (see page 4).
This feature allows the spa to be filtered daily with the heater switched off. The optional QuickTouch
®
QT4
Wireless Remote can also be used to switch the spa heater on. This feature will not work for solar systems,
only gas and electric heaters.
MANUAL HEAT
To enable or disable spa heat when switched on manually:
Menu > Right arrow button:
Select the
Heat
settings.
Right/Left arrow button:
Select the
MANUAL HEAT
setting.
Up/Down arrow button:
Select
OFF
to disable or
ON
to automatically activate
the heat when the
SPA, Up arrow button
(or
HI-TEMP button
for single body
systems) is pressed regardless of the “Heat Source” setting (see page 14).
Left arrow button:
Press the Left arrow button to return to the main status screen.
Spa Temperature
Temp: 85°F
Spa Heat Source
Heat: Heater
Main Menu 2/14
Heat
Main Menu 2/14
Heat
Manual Heat
Manual Heat: On