OmniTek OTR 1001, Руководство пользователя

Страница: 323 / 390

OmniTek OTR 1001 User Guide, v3.1a S-23
S.6 Status
Real-time status information about both the Reference signal and the Test signal is available by
calling up the Status display for that signal. The status of the Reference signal is shown by
calling up the Status display and setting it to show information about Input 1; the status of the
Test signal is shown by calling up the Status display and setting it to show information about
Input 2.
These parts of the Status display show Picture Quality information. They also show SDI Timing
and In-Service Delay Measurement data (see Section N.2).
Figure S-19: Quality Analysis Status Summary.
Note: The quality details shown in the Status display relate to differences between the two
signals and so is the same for both inputs. It can therefore be seen either in a Status display that
is set up to show Input 1 information or in one set up to show Input 2 information
.
Brief information on how to call up the Status display is given below. Further information and
the details it displays is given in Sections E.6 and E.7. How to set the Status display to show
information about Input 1 or Input 2 is described in Section C.3.
The current section also describes the aspects of the Status display that are special to operation in
PQA Mode.