OmniTek OTR 1001, Руководство пользователя

Страница: 294 / 390

OmniTek OTR 1001 User Guide, v3.1 R-2
Initial Set-up
Before the capture is made, the following details need to be defined:
The number of frames that are to be captured
Whether just active video is to be recorded or full frames (where this is given as an
option)
The input stream from which the frames are to be captured.
These details are set in the Capture section of the Gen window’s Properties control:
Figure R-1: Gen window Properties control, showing Capture details.
Control Panel Mouse & Keyboard
Define the required capture as follows:
1. Display the Gen window and call up its
Properties control for example by pressing
the PROPS button. 1. Call up the Properties control for the Gen
window
2. Open the Capture section of the control.
3. Set the Length entry to the number of frames you wish to capture (automatically truncated if
the selected length exceeds the capacity of the framestore).
4. If the Full-frame option is offered, either tick this to capture full frame data or leave it clear
to capture just the active video.
5. Set the Capture Channel entry to the channel from which the video data is to be captured.
Note: The list shown corresponds to the list of inputs that the OTR 1001 is currently set up to
work with. If the input you require is not listed, you probably need to adjust the Analyser
settings on the System page of the Config window.