Oerlikon W000377723, Инструкция по эксплуатации и обслуживанию

Страница: 11 / 307

11 - EN
EN
5.1 - MIG / MAG WELDING – SYNERGY OFF
In manual mode (SYN OFF) this unit can work with self-shielding, flux
core wire. As default unit is ready for gas welding, so for welding without
gas, welding current polarity has to be changed according to the following
steps.
WARNING: ELECTRIC SHOCK CAN KILL!
ALWAYS TURN THE POWER OFF AND UNPLUG THE POWER CORD
FROM THE POWER SOURCE BEFORE CHANGING POLARITY.
For welding without gas, change the
power polarity as following:
■
Connect the earth cable to the
positive output terminal on the
front of the unit.
■
Connect the torch terminal
ring to the negative mounting
post on the voltage.
(Information sticker located
just over the wire feeding
motor on the inside of the unit).
For gas welding remember to reinitiate the default polarity setting as
following:
■
Connect the earth cable to the negative output terminal on the front
of the unit.
■
Connect the torch terminal ring to the positive mounting post on the
voltage.
NOTE: REMOVE DIFFUSER WHEN WELDING WITHOUT GAS TO
AVOID EXCESSIVE HEATING OF THE TORCH.
1
4
3
5
6
7
Mode Key
1
Press the mode key till the MIG/MAG welding screen is viewed on the
display.
MIG/MAG Function Setup Key
5
Press the setup key
5
in MIG/MAG mode to access the parameters’
setup screen.
Use the right setting knob
7
to select “SYN OFF” Mode.
Use the mode key
1
to go back to the MIG/MAG main screen.
Refer to paragraph -
7
for the other parameters’ setting.
Right Setting Knob
7
Use the right setting knob to adjust the welding voltage.
Material Key
4
Use the Material Key to adjust the electronic inductance value.
This setting allows to stabilize the arc by adapting it to the type of material
and to the operator’s hand.
Low inductance = Cold arc, more spatters.
High inductance = Hot arc, few spatters.
Left Setting Knob
3
Use the left setting knob to adjust the wire
speed.
5.2 - MIG / MAG WELDING – SYNERGY ON
With the torch connected, the wire installed and the gas connection done,
earth cable to the negative output terminal on the front of the unit.
1
4
3
5
6
7
Mode Key
1
Press the mode key till the MIG/MAG welding screen is viewed on the
display.
MIG/MAG Function Setup Key
5
Press the setup key
5
in MIG/MAG mode to access the parameters’
setup screen.
Use the right setting knob
7
to select the “SYN ON” mode for normal
welding.
Use the mode key
1
to go back to the MIG/MAG main screen.
Refer to paragraph
7
for the other parameters’ setting.
Right Setting Knob
7
Use the right setting knob to select the thickness of the material to be
welded.
Note: thickness is referred to a fillet welding.
Material Key
4
Use the material key to view the synergic welding curves available on the
unit.
Turn the right setting key
7
or press the material key
4
to choose the
desired synergic curve, suitable to the type of wire and to the gas going to
be used for welding.
To confirm your choice simply press the mode key
1
to go back to the
main screen.
MIG/MAG WELDING SETUP