NSC Sicherheitstechnik Solution F1, Руководство по эксплуатации и установке

Страница: 29 / 69

NSC Sicherheitstechnik GmbH
29/69 14.08.2013
Lange Wand 3 B01050 B01060 Operating Installation Manual Solution F1 20130814.doc
33719 Bielefeld Version S040A13.08
functions Jump to Menu 62
3. Sub menu "Zone settings" to configure the
zones for 2-detector-dependency, internal
alarm zones, technical or fault alarms etc.
Jump to Menu 63
4. Sub menu "Alarm coincidences" to create
alarm dependencies between two or more
zones
Jump to Menu 64
5. Sub menu "Timer programs" to configure up
to 16 timer programs Jump to Menu 65
6. Sub menu "Delay" to configure "Response
time" and "Inspection time" for the alarm
transmission device (only relevant if the main
alarm shall be investigated before passing to
the Fire Brigade).
Jump to Menu 66
7. by "Zone LEDs" the LEDs of zone LED PCB
can be assigned to individual zones.
Jump to Menu M118
36
Settings 1
1. Date/Time 5. Delete program
2. Holidays 6. Delete texts
3. System settings 7. Delete Events
4. Scan detectors 8. Push buttons S_
Cancel more Enter
Settings 1 of FCP
1. To change date, time and day of the week
Jump to Menu 67
2. To configure bank or national holidays which
can be configured individually for any
country
Jump to Menu 68
3. To enter sub menu for system settings
where some individual hardware and
software features can be configured
Jump to Menu 69
4. To enter sub menu for new scanning of
addressable detectors Jump to Menu
70
5. To delete configuration of FCP. Before
deleting there will be a security inquiry
Jump to Picture 71
6. To delete detector texts. Before deleting
there will be a security inquiry Jump to
Picture 72
7. To delete all events in event memory. Before
deleting there will be a security inquiry
Jump to Picture 73
8. To enter sub menu for configuration of
special push buttons S1 to S8 Jump to
Menu 74
For another settings menu please press F3 ("more")
to enter sub menu "Settings 2"
Jump to Menu 37
37
Settings 2
1. Installer code 5. Scan RS485
2. Language 6. Modem
3. Interfaces 7. Network
4. Convent. Detect. 8. Flash Update
Cancel more Enter
Settings 2 of FCP
1. To change installer access code Jump to
Menu 75
2. To change the panel’s language Jump to
Menu 76
3. To enter sub menu of 3 serial interfaces
4. RS-232. It is possible to configure the
interfaces with different protocols and
different baud rates
Jump to Menu 77
5. To configure alarm thresholds for
conventional detectors so that it is possible
to use conventional detectors of different
manufacturers
Jump to Menu 78
6. After pressing "5" the RS-485 devices
connected to the RS-485 interfaces will be