Notifier ID50 SERIES, Инструкция по установке, пусконаладке и конфигурации

Страница: 80 / 94

ID50 Series Panel - Installation, Commissioning & Configuration Manual
Configuration
Mode
74 997-263, Issue 4
September 2002
5.9 Access Options
The Access options menu allows the configuration of the
following access passcodes:
a. Up to ten (10) User passcodes.
b. One Commissioning engineer passcode.
The Access option is available from the Commissioning
menu. To configure access passcodes:
1 At the Commissioning menu, using the numeric
keypad press the ‘
5
’ button to display the Access
options menu.
2 Use the numeric keypad to select the appropriate
option:
a. Press the ‘
1
’ button to select the User option.
b. Press the ‘
2
’ button to select the Engineer option.
3 Selecting the User option (‘
1
’ on the numeric
keypad) displays the following menu:
i Use the ‘
2
/
8
’ buttons to select a user access code
number (range 0 to 9).
ii Press ‘
1
’ on the numeric keypad to delete the
currently displayed access code and disable that user.
iii Press the ‘
6
’ to display the change menu, see below.
4 The change menu prompts for entry of a new access
code:
Note: If the Engineer option is selected the access code
number is replaced by (ENG).
5 Using the numeric keypad, enter a new four (4) digit
passcode and press ‘
5
’ to confirm. After editing a
‘User’ passcode the display automatically returns to
the User passcode selection menu. The ‘Engineer’
passcode returns to the Access menu.
[S1 COMM] 1 : Setup 2 : Circuit
3 : CBE Rules 4 : Zones 5 : Access × : More
[S1 Access] 1 : User 2 : Engineer
[S1 Access] Passcode 0 = nnnn
>:Change 1:Delete × : More<:Cance l
[S1 Access] Passcode 3 = nnnn
>:Change 1:Delete × : More<:Cance l
[S1 Access] Passcode 3 = ________
>:Change 1:Delete × : More<:Cance l
[Setup] Passcode 0 = nnnn
Enter new value ____
3
: Confirm <:Cancel
or
5
1
8
1
2
6
5