ID50 Series Panel - Installation, Commissioning & Configuration Manual
Inst
allation Guide
11
997-263, Issue 4
September 2002
2.5 Dismantling the Panel
For installation purposes, it is recommended that the
cover is removed from the back box and stored in a safe
place until ready for commissioning.
If any other trades, e.g. plasterers or decorators, will be
working in the vicinity after fitting the ID50 Series Panel,
it is strongly recommended that before re-fitting the cover
you remove the panel electronics and store in a safe place
until ready for commissioning. The main components
within the ID50 Series Panel are shown below.
ID50 Series Panel Assembly
A. Back box
B. PCB Assembly
C. LCD Unit
D. Fascia & Control Keypad
E. Cover
2.5.1 Removing the Cover
To remove the ID50 Series Panel cover, it is
recommended that the following procedure is carried out
on a work bench BEFORE siting the panel on the wall:
1
Remove the four M3 x 6mm screws and washers (A)
using a No. 1 Posidriv screwdriver, or the four hex
button-headed screws and clear washers (B) using a
2mm hex key, from the cover, and store safely.
2
Carefully withdraw the cover away from the back box,
until the earth blade terminal (C) within the cover is
accessible.
3
Carefully detach the shrouded earth lead spade
terminal (D) from the earth blade terminal (C) located
in the left-hand inner side wall of the cover.
Note:
All blade connections to earth incorporate a locking
barb. To make a connection push the shrouded
receptacle on to the earth blade (1). To remove
this connection, pull the shroud (2), NOT the earth
wire.
4
Remove and store the cover in a safe place.
Before installing the back box, remove the panel
electronics (see
Section 2.5.2, Panel Electronics
).
A
B
C
D
E
Содержание ID50 SERIES
Страница 1: ...ID50 60 installation commissioning configuration manual 997 263 Issue 4 September 2002...
Страница 2: ......