Notifier ID50 SERIES, Инструкция по установке, пусконаладке и конфигурации

Страница: 91 / 94

ID50 Series Panel - Installation, Commissioning & Configuration Manual
Appendix 2 - ID60 Panel Differences
A2 - 3
997-263, Issue 4
September 2002
A2.2 Learning Individual VIEW
TM
Sensors
When installed on a loop from the ID60 Panel , each
VIEW
TM
sensor is assigned the Advanced VIEW
TM
Sensor
(AVS) type by default. This may then be configured as
Advanced VIEW
TM
Reference (AVR) type.
A VIEW
TM
sensor may be learnt in the same manner as
any sensor but has an additional ‘Type’ configuration
option. The procedure to configure the sensor type is as
follows:
1 Using the numeric keypad, press ‘
1
’ to select the
sensors configuration option.
2 At the prompt, using the numeric keypad enter the
address of the VIEW
TM
sensor to be edited and confirm
using ‘
5
’.
3 The LCD then shows current settings and editable
parameters. Using the numeric keypad, press ‘
2
’ to
select the ‘Type’ option.
Note: Use ‘
2
/
8
’ to select the next/previous address
respectively.
4 The LCD then displays the VIEW
TM
device type
selection menu. Using the numeric keypad, press ‘
1
’
or ‘
2
’ to select the ‘AVS’ or ‘AVR’ type respectively.
The display automatically returns to the previous
menu, as shown below:
[S1 Device] 1 : Sensors 2 : Modules
[Sensor nn - AVS] 1 : Zone (nn) 2 : Type
3 : Sensitivity 4 : [ Blank/Existing Text ]
[Sensor] Enter Address ____
[Sensor nn - AVR] 1 : Zone (nn) 2 : Type
3 : Sensitivity 4 : [ Blank/Existing Text ]
[Sensor nn - AVS] Select Type :
1 : AVS 2 : AVR < : Cancel
1
2
or
1 2