Nord Drivesystems SK 200E Series, Руководство пользователя

Страница: 249 / 265

9 Additional Information
BU 0200 GB Subject to technical alterations 249
9.6 Operation with FI circuit breakers
With SK 200E frequency inverters (except 115V devices) leakage currents of > 40mA are to be expected
with an active mains filter. If possible, an FI circuit breaker for the protection of personnel should not be used.
If the frequency inverter is to be used with an FI circuit breaker for the protection of personnel, the leakage
currents to earth must be reduced to 10 - 20 mA by means of jumpers. However, with "operation on an IT
network" the FI loses its specified degree of interference protection.
Further details can be found in Section 2.7.5 - 2.7.6.
9.7 System bus
Frequency inverters and components of the SK 200E series communicate with each other via the system
bus. This bus system is a CAN bus with a Canopen protocol. Up to four frequency inverters and their
associated components (field bus module, absolute encoder, I/O modules etc.) can be connected to the
system bus. Integration of the components into the bus does not require any BUS-specific knowledge on the
part of the user.
It is only necessary to take care that the correct physical structure of the bus system and the correct
addressing of the participants are complied with.
The connection of the individual NORD components is described in this manual
(See section 2.8.2, 3.4, and 3.5).
Physical structure
Standard CAN
Bus length 20m with a wire cross section of 0.25mm² (AWG23)
Structure preferably linear
Spur cables possible, (max. 6m)
Termination resistors 120
Ω
, 250mW at both ends of a system bus
(with SK 200E-… or SK xU4-… via DIP switches)
Baud rate 250kBaud - preset
SYSTEM BUS
Configuration Example
1. FI 2. FI 3. FI 4. FI
1. I/O
Extension
8. I/O
Extension
Field Bus
Option
additional participants
(I/O extensions, CANopen encoder
Note:
Terminal77 = System bus + (CAN H)
Terminal78 = System bus - (CAN L)
Terminal numbers may differ