Nord Drivesystems SK 200E Series, Руководство пользователя

Страница: 185 / 265

6 Parameterisation
BU 0200 GB Subject to technical alterations 185
Parameter
{Factory setting}
Setting value / Description / Note Device Supervisor
Parameter
set
P546 Func tion Bus setpoint 1 ... 3
S P
In this parameter, a function is assigned to the output setpoint during bus actuation.
NOTE: For further details, please refer to the relevant bus manual or the description for
(P400). (Values from 0% … 100% correspond to 0000
hex
… 4000
hex
,)
For standardisation of the setpoint values: See also (Section 9.10).
[-01] = Bus setpoint value 1
[-02] = Bus setpoint value 2 (only for PPO type 2 or 4)
[-03] = Bus setpoint value 3 (only for PPO type 2 or 4)
Possible setting values:
0 ... 24
{ [-01] = 1 }
{ [-02] = 0 }
{ [-03] = 0 }
0 = Off
1 = Setpoint frequency (16 Bit)
2 = Frequency addition
3 = Frequency subtract ion
4 = Minimum frequency
5 = Maximum frequency
6 = Cur rent val ue , process c on tr o l ler
7 = Nom inal val ue , process c on tr o l ler
8 = PI current frequency
9 = PI limited current freq uency
10 = PI sup e rv i s e d cur rent freq uency
11 = Torque current limit ation (limited)
12 = Torqu e curr ent limit ation (switch- off )
13 = Current limit (limited)
14 = Current limit (switch- off )
15 = Ramp time
16 = Pre-tension torque ((P214) multiplication)
17 = Multiplication
18 = Curve control (Curve travel calculator)
19 = Servo mode torque
20 = BusIO InBits 0-7
21 = ..24 reserved for Posicon
31 = Digital output first IOE (sets status DOUT)
32 = Analog output first IOE (sets value AOUT)
P549 Pot entiometer Box function
S
This parameter provides the possibility of adding a correction value (fixed frequency, analog,
bus) to the current setpoint value by means of the SimpleBox/ParameterBox keyboard.
The adjustment range is determined by the auxiliary setpoint value P410/411.
0 ... 3
{ 1 }
0 = Off
1 = Setpoint frequency , with(P509)
≠
1
control via USS is possible
2 = Frequency addition
3 = Frequency subtract ion