Chapter
3: Web Management
Web Management - Configure
NGSME48T4H Switch User Manual | 23
3.1. Web Management - Configure
In here you can access all the configuration options of the switch. The configuration options
here include:
System:
Here you can configure basic system settings such as system information,
switch IP, NTP, system time and log.
Green Ethernet:
You can enable EEE (Energy Efficient Ethernet) function on each port
or adjust LED flashing intensity to conserve and save power used by the switch.
Ports:
You can view the connection status of all the ports on the switch, as well as set
port connection speed, flow control, maximum frame length, and power control mode.
DHCP:
Here you can set DHCP snooping and DHCP relay, as well as IP settings.
Security:
The Security option allows you to make settings that secures both the switch
itself or your network.
Aggregation:
Aggregation allows you to combine multiple physical ports into a logical
port, thus allows the transmitting speed exceeding the limit of a single port.
Loop Protection:
A network loop might cause broadcast storm and paralyze your entire
network. You can enable loop protection function here to prevent network loop.
Spanning Tree:
Spanning Tree Protocol is a network designed to ensure a loop-free
network and provide redundant links that serve as automatic backup paths if an active
link fails. This switch supports STP, RSTP (Rapid STP), and MSTP (Multiple STP).
IPMC Profile:
IPMC stands for IP Multi-Cast. The IPMC profile is used to deploy the
access control on IP multicast streams. It is allowed to create at maximum 64 Profiles
with at maximum 128 corresponding rules for each.
MVR:
MVR stands for Multiple VLAN Registration, a protocol that allows sharing
multicast VLAN information and configuring it dynamically when needed.
IPMC:
Here you can set IGMP snooping (for IPv4) or MLD snooping (for IPv6). These
protocols can reduce the network loading while running band-width demanding
applications such as streaming videos by eliminating excessive data transmitting.
LLDP:
LLDP stands for Link Layer Discovery Protocol, a protocol that allows the switch
to advertise its identity, capabilities, and neighbors on the network.
PoE:
Here you can enable/disable the PoE function on each port or assign the power (in
Watt) for each port.
MAC Table:
When a network device is connected to the switch, the switch will keep its
MAC address on the MAC table. This section provides settings for the switch’s MAC
address table.
