NF KP3000S, Инструкция по эксплуатации

Страница: 20 / 290

1. Outline
PROGRAMMABLE AC/DC POWER SOURCE 2
1.1 Overview
Programmable AC/DC power source KP3000S is a multifunction power source which can output 3
kVA AC / 3 kW DC at a maximum. It also provides various interfaces such as the external control
input/output, communication interface, and remote controller (optional) to address a wide variety of
usage. In addition you can configure single-phase three-wire or three-phase four-wire power source
system with a respective System Cable (optional).
1.2 Polyphase System Configuration
You can connect two or three KP3000Ss using an optional System Cable to allow single-phase
three-wire output or three-phase four-wire output, respectively (polyphase system).
1.3 Features

Various interfaces to address a variety of usage
In addition to RS232, USB, and GPIB to use for the remote controlling from a computer or
sequencer, you can use a contact/TTL signal to turn the output on/off or switch the memory without
using a computer. The product also offers the status output for showing the device status and the
output which is synchronized with Sequence or Simulation step. With these functions you can
achieve various types of systemization and automatization. The AGC function and Autocal function
to compensate the output voltage drop are also provided.

Variable current limiter
This function can limit the effective value and the positive/negative peak value of the output current
where the limiting value is variable. You can set the limiter so that the output is turned off when the
limited condition continues for a certain time.

Globally adjustable power inlet without restricted by the power supply environment
KP3000S supports a wide range of power input from 100 V to 230 V.

Feature-rich measurement function
On the panel the product displays the effective value, peak value, average DC value, current
peak-hold value, and active/apparent power of the output voltage/current, the power factor, crest
factor, reactive power, and harmonic current.

Control Software (Optional)
You can perform the following operations by using optional Control Software:

Operations same as those performed on the control panel

Editing/transferring/exporting the arbitrary waveform data*

Data logging (importing the measured values)