NF KP3000S, Инструкция по эксплуатации

Страница: 254 / 290

10.
Specifications
PROGRAMMABLE AC/DC POWER SOURCE 236
Specifications are valid under the following settings and conditions and after a warm-up period of
30 minutes at least, unless otherwise noted.
Load
Resistance load of power factor 1
Signal source INT (internal signal source)
Output voltage waveform Sine wave
Remote sensing Off
AGC/Autocal Off
Current Limiter
Factory default setting
Output terminal Output terminal block on the rear panel
[set] indicates a setting value, and [rdg] indicates a read value.
The description noted with "/" indicates that the specification changes by the output range, such as
"100 V range specification/200 V range specification."
A value with the accuracy is the guaranteed value of the specification. However, an accuracy noted
as reference value shows the supplemental data for reference when the product is used, and is not
under the guarantee. A value without the accuracy is the nominal value or representative value
(shown as typ.).
KP3000S corresponds to Clause 2 (8) Frequency converter, Appendix 1 of Export Trade Control
Ordinance. The permission for exportation of the Japanese Administration is necessary for export
outside Japan.
10.1 Output Function
KP3000S
Output Function Continuous, Sequence, Simulation
10.2 Output Range
KP3000S
Output Range
100 V range, 200 V range