NF KP3000S, Инструкция по эксплуатации

Страница: 272 / 290

10.
Specifications
PROGRAMMABLE AC/DC POWER SOURCE 254
10.22.3 External Signal Input (only EXT and ADD)
This multiplies the input signal by the specified gain and outputs it. For ADD, the internal signal
source is added.
EXT: Output voltage (V) = External signal input (V) x Gain (V/V)
ADD: Output voltage (V) = External signal input (V) x Gain (V/V) + Internal signal source setting
(V)
KP3000S
Factory
default
Setting Range for gain 100 V range: 0.0 to 220.0 times 100
200 V range: 0.0 to 440.0 times 200
Setting resolution 0.1
Gain accuracy

5%
(DC, 45 Hz to 65 Hz, the gain is the factory default, the rated output
voltage, no load)
Input-output phase In-phase
Input terminal BNC connector (rear panel, unbalanced)
Also used as the external synchronization signal input
Input impedance
1 M

Input voltage range

2.2 V (A/D resolution 10 bit)
Nondestructive
maximum input
voltage

10 V
Input frequency range DC to 550 Hz (sine wave)
DC to 100 Hz (other than sine wave)
Note: This function cannot be used for the polyphase system.
10.23 General Function
Description
Factory
default
LCD
display setting Contrast 0 to 99
Color Blue tone or white tone White tone
Beep
(key operation,
erroneous operation)
On or Off
Alarms on abnormal situation regardless of the setting
On
Key lock On or Off
On: Only key lock-off and output-off are available
Off
Output relay control On: The output relay is used to turn the output on/off
Off: The output relay is not used. High impedance to
turn the output off
On
Output setting
at power-on On or Off
On: Output on after power-on
Off
Trigger output setting Polarity: positive or negative
Pulse width: 0.1 ms to 10 ms (resolution 0.1 ms)
Negative
10 ms
Time unit setting for
Sequence and Simulation
ms or s s
Reset function Resets the items stored in the System Setting Memory (excluding the
external interface setting) and the items that are to be reset at
power-on, to the factory default settings.