NF KP3000S, Инструкция по эксплуатации

Страница: 51 / 290

3.2 Power On/Off
KP3000S
33
4.
If the output function selection is set to the Continuous function and the output-on at power-on
setting is on, the output is turned on after the confirmation message to inform that the output is
automatically turned on is displayed for about 10 seconds. If you press the ENTER key while
this message is displayed, you can cancel the setting of automatic output-on. For detailed
information about the output-on at power-on setting, see
4.22
.
3.2.4 The Settings Loaded after Startup
For the Continuous function, the output settings are invoked from the Basic Setting Memory No.1
and other settings are loaded from the System Setting Memory. For details, see
4.8
and
10.24
.
For the Sequence function and the Simulation function, the factory default settings are loaded for the
content of each step.
If you changed the configuration of a polyphase system, the settings are invoked depending on the
output phase mode.
3.2.5 Checking the Rated Power
On the screen after startup, the rated power icon is displayed in the position shown in Figure 3–7.
The value in the icon indicates the maximum electric power that can be output. In Figure 3–7, the
maximum electric power is 3.0 kVA.
If the rated power is restricted by the power unit energization setting, the icon is highlighted as
shown in Table 3-4. For detailed information about the power unit energization setting, see
4.24
.
Rated
power icon
Figure 3-7 The Rated Power Icon
Table 3-4 How the Rated Power Icon is Displayed Depending on the Power Unit
Energization Setting
Normal icon
Example:
All power unit energization settings are enabled. The rated power is set to the
maximum value that the system and the power supply voltage can provide.
Highlighted icon
Example:
Because some power unit energization settings are disabled, the rated power is
restricted.
--------
Notes
------------------------------------------------------------------------------------------------------------
 For a polyphase system, the rated power is displayed for each phase.
-----------------------------------------------------------------------------------------------------------------------------
3.2.6 Power Off
Disable the output and ensure the OUTPUT LED is off before pressing "Off" side of the power
switch. All screens disappear and all LEDs turn off, then the power input and the output are blocked
inside the system. For a polyphase system, although the order for turning off cabinets is not
significant, a communication error message may appear if the interval between the operations of
turning off the cabinets is too long. This does not cause any problem.