11. To verify that the AP runs the new firmware version, log back in to the AP.
The firmware version is stated in the Firmware Version field at the top right of the
BASIC Home page.
Enable the AP to automatically update the firmware
You can let the AP check for new firmware and automatically update the firmware if new
firmware is available.
To let the AP check for new firmware and automatically update the firmware:
1. Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 34.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Firmware Update.
The Firmware Update page displays.
5. In the Router Auto Firmware Update section, select the Enable radio button.
By default, the Disable radio button is selected.
6. Click the Apply button.
Your settings are saved.
User Manual
90
Maintain and Monitor
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
