To configure a static IP address, click the Use fixed IP Address (not
recommend) button, and in the fields that display below the Learn more
button, change the IP address information.
-
To change the device name before you change the operation mode, click the
Edit button.
-
To change the WiFi settings before you change the operation mode, click the
Wireless Setup button. For more information, see Set up or change an open
or secure WiFi network on page 49.
6. Click the Apply button.
Your settings are saved and the AP is reconfigured in the new operation mode.
Disable LED blinking or turn off LEDs
The LEDs on the front panel of the AP indicate activities and behavior. By default, the
Internet LED, LAN LED, and WLAN LEDs blink when the AP detects data traffic. You can
disable LED blinking for data traffic, or turn off all LEDs except the Power LED.
To disable LED blinking or turn off the LEDs:
1. Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 34.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
User Manual
115
Maintain and Monitor
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
