NEC Versa LX, Руководство пользователя

Страница: 57 / 215

3-12 Using the Software
– Auto Suspend Timeout — Defines how much time elapses
from the time the system enters Standby mode to the time the
system automatically enters Suspend Mode.
!
LCD Suspend — Allows you to suspend/resume when the LCD panel
is closed.
!
Suspend Option — Specifies either Suspend or Save to File (STF) as
the default power management mode. In Suspend, after a specified
amount of inactivity, your NEC Versa shuts down all devices as you
specified in Power Management Setup or applies default timeouts. All
your data is automatically recovered from where you left off when
you Resume.
!
Automatic STF — After 30 minutes in Suspend mode the current file
is automatically saved to a special file on the hard disk and the system
shuts down. To resume, you must press the power button. The system
reads the saved file and sets up your system accordingly.
If Auto Save to File is set to Off and the save-to-file area is present on
your hard drive, pressing the
Fn-Power/Sleep
key combination puts
the system into Save to File mode. (Before using the Power/Sleep
button to put the system into Suspend mode, set the System Switch
BIOS parameter to Sleep button.) For details about creating the
save-to-file area, see the section, “HDPREPEZ Utility,” later in this
chapter.
!
Panel Brightness — Selects the LCD screen brightness.
!
Suspend Warning Tone — Specifies whether the system warning tone
sounds when Suspend mode starts. It is best to keep this option
enabled.
!
Remote Power On — Allows the serial port modem or LAN board to
wake the system on a ring signal.
!
Resume Signal — Selects the signal which triggers a modem ring
resume.
!
Wake Up from Suspend Alarm/Resume Alarm Time — Allows the
alarm to resume the system from suspend. Designates the time
parameter in five minutes increments.