Miyachi LMV1000, Руководство пользователя

Страница: 258 / 259

CHAPTER 13: TROUBLESHOOTING
LMV1000 (G)(E) AIR-COOLED LASER MARKER
990-541 13-3
Error
Code
Problem LD
1
Cause/Corrective Action
42
RF Power Reflective waveform
excessive
OFF
The measured back RF reflection is excessive. The possible
causes for this error are:
Poor RF cable connection, check cable connection.
Faulty RF Power Unit
Faulty Q-Switch
Recycle the power on the Marker. If this error persists, contact
Miyachi America.
50 RF Temperature Error OFF
The RF Unit is overheating. The possible causes for this error
are:
Dirty Control Unit Air-filter, clean as necessary.
High Ambient temperature,
t
95
q
F (~35
q
C)
Perform corrective action, and then wait at least 10 minutes
before re-starting the Marker. If this error persists, contact
Miyachi America.
51 LD Temperature Error OFF
The LD (Laser Diode) Module is overheating. The possible
causes for this error are:
Dirty Control Unit Air-filter, clean as necessary.
Faulty Peltier Cooling Unit
High Ambient temperature,
t
95
q
F (~35
q
C)
Perform corrective action, and then wait at least 10 minutes
before re-starting the Marker. If this error persists, contact
Miyachi America.
52 Crystal Temperature Error OFF
The Nd:YVO
4
Crystal is overheating. The possible causes for
this error are:
Dirty Control Unit Air-filter, clean as necessary.
Faulty Peltier Cooling Unit
High Ambient temperature,
t
95
q
F (~35
q
C)
Perform corrective action, and then wait at least 10 minutes
before re-starting the Marker. If this error persists, contact
Miyachi America.
60–75 Control Unit error —
Control Unit errors.
Recycle Power. If the error reoccurs, contact the Miyachi
America Corporation.
1. This column shows the condition of the LD (Laser Diode) Module when the error is detected. A “—“ indicates no
change.