Miyachi LMV1000, Руководство пользователя

Страница: 28 / 259

LMV1000 (G)(E) AIR-COOLED LASER MARKER
990-541 4-1
CHAPTER 4
Installation and Connection
(1) Installation Location
When planning for the installation of the Marker, assure that the following conditions are met:
x
The Marker should be placed in a dedicated laser operation area. The person responsible for the
area (the Laser Safety Officer) must isolate the laser operation area from other work areas and
display signs warning that the laser operation area is off limits to unauthorized personnel.
x
See Appendix A: Technical Specifications for specific weight and dimensional requirements.
x
Use proper tools (wire strippers, pressure wire connectors, etc.) for termination of the
connecting cables.
x
The Marker should be placed on a firm, level surface that is free from vibration. Install the
Oscillator and workpiece on the same stand, to prevent marking distortion due to vibration.
x
Do not operate the unit where there is considerable dirt, dust, oil mist, chemicals, fumes,
moisture, or near a high-frequency noise source.
x
The ambient temperature should be between 41°F and 95°F (5°C - 35°C) and the relative
humidity 20% to 90%, non-condensing.
x
The area should have no rapid temperature fluctuations, which may cause dew condensation on
the optical surfaces.
x
To accommodate the standard cable lengths, the Control Unit, Oscillator and Computer must be
located within 9.8 feet (3m) of each other. Longer cables are available through special order.
x
If the outside of the Marker is stained, wipe it with a dry or slightly moistened cloth. If it is
badly stained, use neutral detergent or alcohol to clean it. Do
not use paint thinner, acetone,
benzene, etc. which can discolor or deform the parts.
x
Allow adequate clearance on all sides of the Marker to allow for cooling, maintenance and
servicing. Use the
minimum distances shown below:
Oscillator
Control Unit