Replacement of lamp bulbs
Maintenance 11-27
11
3. To install the bulb, perform the removal
steps in reverse.
E01004202767
1. Open the tailgate.
2. Remove the screws (A), and then move
the lamp unit towards the rear of the vehi-
cle to unfix the notch (B) and pins (C) of
the lamp unit.
3. Turn the socket anticlockwise and remove
it, and then pull the bulb out of the socket.
4. To install the bulb, perform the removal
steps in reverse.
NOTE
When installing the lamp unit, first insert the
notch (B) into the hole on the body, and then
push on the lamp unit to fit it into place.
Rear combination lamps
D- Rear turn-signal lamp
E- Tail lamp and stop lamp (LED)-cannot
be replaced
NOTE
The tail lamp and stop lamp use an LED
instead of the bulb.
If you need to repair or replace these lamps,
contact a MITSUBISHI MOTORS Author-
ised Service Point.
NOTE
When installing the lamp unit, align the
notch (F) and pin (G) on the lamp unit with
the clip (H) and hole (I) in the body.
Содержание OUTLANDER PHEV 2021
