Mitsubishi Electric PUHY-(E)P300, Руководство по обслуживанию

Страница: 174 / 302

[
IX
Troubleshooting ]
- 165 -
HWE07010 GB
1. Error Code
Drain pump abnormality (Models with a drain sensor)
2. Error definition and error detection method
1) Make the drain sensor thermistor self-heat. If the temperature rise is small, it is interpreted that the sensor is immersed in
water. This condition is considered to be a preliminary error, and the unit goes into the 3-minute restart delay mode.
2) If another episode of the above condition is detected during the preliminary error, this is considered a drain pump error, and
"2502" appears on the monitor.
3) This error is always detected while the drain pump is in operation.
4) The following criteria are met when the criteria for the forced stoppage of outdoor unit (system stoppage) are met.
∗
"Liquid pipe temperature - inlet temperature - 10 K" has been detected for 30 minutes.
∗
The immersion of drain sensor is detected 10 consecutive times.
∗
The conditions that are listed under items 1 through 3 above are always met before the criteria for the forced stoppage of
the outdoor unit.
5) The indoor unit that detected the conditions that are listed in item 4 above brings the outdoor unit in the same refrigerant circuit
to an error stop (compressor operation prohibited), and the outdoor unit brings all the indoor units in the same refrigerant circuit
that are in any mode other than Fan or Stop to an error stop. "2502" appears on the monitor of the units that came to an error
stop.
6) Forced stoppage of the outdoor unit
Detection timing: The error is detected whether the unit is in operation or stopped.
This error is detected whether the unit is in operation or stopped.
7) Ending criteria for the forced stoppage of outdoor unit
Power reset the indoor unit that was identified as the error source and the outdoor unit that is connected to the same refrig-
erant circuit.
Forced stoppage of the outdoor unit cannot be cancelled by stopping the unit via the remote controller.
(Note) Items 1) - 3) and 4) - 7) are detected independently from each other.
The address and attribute that appear on the remote controller are those of the indoor unit (or OA processing unit)
that caused the error.
3. Cause, check method and remedy
2502
Cause Check method and remedy
(1) Drain pump failure Check for proper functioning of the drain pump mecha-
nism.
(2) Drain water drainage problem
ΠClogged drain pump
ΠClogged drain piping
Check for proper drainage.
(3) Adhesion of water drops to the drain sensor
ΠTrickling of water along the lead wire
ΠRippling of drain water caused by filter clogging
1) Check for proper lead wire installation.
2) Check for clogged filter.
(4) Indoor unit control board failure
ΠDrain pump drive circuit failure
ΠDrain heater output circuit failure
If the above item checks out OK, replace the indoor unit
control board.
(5) Items (1) through (4) above and an indoor unit elec-
tronic valve closure failure (leaky valve) occurred si-
multaneously.
Check the solenoid valves on the indoor unit for leaks.