Mitsubishi Electric GT15, Руководство по подключению

Страница: 432 / 864

12 - 12
12. CC-Link IE FIELD NETWORK CONNECTION
12.4 PLC Side Setting
(b) Network Configuration Settings
: Necessary : As necessary : Not necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
(1) When changing the unit parameter
After writing unit parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset
the PLC CPU.
(2) GOT station type
Set the GOT as an intelligent device station.
(c) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number
cannot be set twice or more (multiple times).
Therefore, the one that can access to other station
from the request source host GOT is 238 kinds of
[Target Station Network No.]s.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
11.3.3 Routing parameter setting
Item Set value
Setting necessity
at GOT
connection
Rx/RY,
RWw/RWr
Setting (1)
*1
Rx/RY
setting Station
No.1
Start 0000
H
End 00FF
H
RWw/RWr
setting
Station
No.1
Start 0000
H
End 00FF
H
Reserved/Error Invalid Station No setting
Item Range
Target Station Network No. 1 to 239
Relay Station Network No. 1 to 239
Relay Station No. 1 to 120