Mitsubishi Electric GT15, Руководство по подключению

Страница: 416 / 864

11 - 22
11. CC-Link IE CONTROLLER NETWORK CONNECTION
11.4 PLC Side Setting
(b) Network range assignment
: Necessary : As necessary : Not necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller
module (Q Series), either turn the C Controller module
(Q Series) OFF and then ON or reset it.
(c) Routing parameter setting
Up to 238 [Transfer Network No.]s can be set.
However, the same transfer network number
cannot be set twice or more (multiple times).
Therefore, the one that can access to other station
from the request source host GOT is 238 kinds of
[Transfer Network No.]s.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
11.3.3 Routing parameter setting
Item Set value
Setting
necessity at
GOT
connection
Total stations 2
LB/LW
settings (1)
LB
Station
No.1
Start 0000
H
End 00FF
H
Station
No.2
Start 0100
H
End 01FF
H
LW
Station
No.1
Start 00000
H
End 000FF
H
Station
No.2
Start 00100
H
End 001FF
H
LX/LY settings
*1
No setting
Monitoring time (Use default value)
Specify I/O master station
*1
No setting
Specify reserved station No setting
Supplementary settings (Use default value)
Item Range
Transfer target network No. 1 to 239
Relay network No. 1 to 239
Relay station No. 1 to 120