Mitsubishi Electric GT15, Руководство по подключению

Страница: 339 / 864

8. ETHERNET CONNECTION
8.4 PLC Side Setting
8 - 53
1
P
R
EP
ARA
T
OR
Y
P
R
OCEDURES
FOR
MONIT
O
R
ING
2
D
E
VICE RA
NGE
T
H
A
T
CAN
B
E
SET
3
ACCESS
RA
N
G
E
F
O
R MONIT
O
R
ING
4
HOW T
O
MONIT
O
R
REDUNT
ANT
SYS
TEM
5
BUS CONNECTION
6
DIR
E
CT
CONNECTION T
O
CPU
7
COMP
UT
E
R
L
INK
CONNE
C
T
ION
8
E
T
HE
RN
E
T
CONN
E
C
T
ION
8.4.12 Connecting to Built-in Ethernet
port FXCPU (FX
3GE
)
This section describes the settings of the GOT and
Ethernet module (FX Series) in the following case of the
system configuration.
POINT POINT POINT
FX
3GE
For details of the FX
3GE
, refer to the following manual.
FX
3GE
SERIES PROGRAMMABLE
CONTROLLERS HARDWARE MANUAL

System configuration
*1 These setting items do not exist at the PLC side. However,
the virtual values must be set on the GOT side.
■
[Controller Setting] and [Ethernet] of GT
Designer3

Ethernet parameter settings of FX
3GE
(1) Ethernet settings
Set the Ethernet parameter at [FX Parameter] on GX
Works2.
To set FX
3GE
, GX Works2 Ver.1.91V or later is required.
For details on the setting of FX
3GE
, refer to the following
manual.
FX
3GE
SERIES PROGRAMMABLE
CONTROLLERS HARDWARE MANUAL
:Required :Set if necessary :Not required
*1 The default value of IP address is 192.168.1.250. Set the IP
address corresponding to the system configuration.
POINT POINT POINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again.
<GOT>
(The settings other than the
following are set to the default)
PLC No. : 1
IP address : 192.168.0.18
Port No. : 5019
Communication
format : TCP (fixed)
PC No. : 2 (virtual)
Network No. : 1 (virtual)
IP address : 192.168.0.19
Port No. : 5556 (fixed)
Communication
format : TCP (fixed)
<Ethernet module> (The settings other than the
following are set to the default)
*1
*1
[Controller Setting] and [Ethernet] of GT
Designer3
■
■ Ethernet parameter settings of FX3GE
Item Setting
Setting
(with GOT connected)
Channel CH1
IP Address
192.168.1.250
*1
Open Setting Refer to (2).
Communication Data
Code
(Use default value.)
Disable direct
connection to
MELSOFT
Do not respond to
search for CPU on
network