Mitsubishi Electric FR-A800, Инструкция по эксплуатации

Страница: 177 / 1042

Basic operation Basic operation procedure (External operation)
FR-A800 4 - 29
4.6.6 Changing the frequency (60 Hz, initial value) at the maximum current input
(at 20 mA, initial value)
Change the maximum frequency
쑶
Example
쑴
Changing example:
With a 4 to 20 mA input frequency setting potentiometer, change the frequency at 20 mA from
60 Hz (initial value) to 50 Hz.
Adjust the setting so that the inverter outputs 50 Hz when 20 mA is input. Set "50 Hz" in Pr. 126.
Operation
Parameter selection
Turn until (Pr. 126) appears.
Press to show the present set value. (60.00 Hz)
Changing the maximum frequency
Turn to change the set value to " ". (50.00 Hz)
Press to enter the setting." " and " " flicker alternately.
Checking the mode/monitor
Press three times to change to the monitor / frequency monitor.
#
Start
Turn ON the start switch (STF or STR), then turn the potentiometer (frequency setting potentiometer) clockwise slowly
to full. (Refer to steps
and
#
in section 4.6.5.) Operate at 50 Hz.
Tab. 4-20: Change the frequency of the maximum analog value
NOTES To set the frequency at 4 mA, use the calibration parameter C5.
Other adjustment methods for the frequency setting current gain are the following: adjustment
by applying a current through terminals 4 and 5, and adjustment using a specified point without
applying a current through terminals 4 and 5.
Parameters referred to
Pr. 126 Terminal 4 frequency setting gain frequency => page 5-401
C5 (Pr. 904) Terminal 4 frequency setting bias frequency => page 5-401
C7 (Pr. 905) Terminal 4 frequency setting gain => page 5-401
Frequency setting
signal
Output frequency [Hz]
0
0
0
0 100%
20 mA
5 V
10 V
C7 (Pr. 905)
Gain Pr. 125
Initial value
Bias
60 Hz
(50 Hz)
C5
(Pr. 904)
20
4
1
2
C6 (Pr. 904)