Mitsubishi Electric FR-A800, Инструкция по эксплуатации

Страница: 578 / 1042

(T) Multi-Function Input Terminal Parameters Parameters
5 - 398
Example
쑴
When Pr. 73 = "5"
By the terminal 1 (main speed) and terminal 2 (auxiliary) input, the setting frequency is set as shown
in the figure below.
쑶
NOTES To use terminal 4, the AU signal needs to be turned ON.
To make compensation input for the multi-speed operation or remote setting, set Pr. 28 "Multi-
speed input compensation selection" = "1" (with compensation) (initial value "0").
After changing the Pr. 73 setting, check the voltage/current input switch setting. Incorrect setting
may cause a fault, failure or malfunction. (For the settings, refer to page 5-389.)
Parameters referred to
Pr. 28 Multi-speed input compensation selection => page 5-189
Pr. 73 Analog input selection => page 5-389
75
50
37,5
25
12,5
0
0 2,5 5
Terminal 1 input voltage [V]
Terminal 2:
5 V DC input (150 %)
Se
t f
re
q
u
e
n
c
y
[
Hz]
Terminal 2:
2.5 V DC input (100 %)
Terminal 2:
0 V DC input (50 %)