Mitel Inter-Tel 5000, Руководство по установке и обслуживанию

Страница: 353 / 468

Chapter 6: Reference
Code-Accessible Endpoint Features
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
Page 6-31
Mute On/Off 314 (Not used on single line endpoints.) Turns the microphone on or off during
a call. If muted, the user can hear the other party, but the party cannot
hear the user. Endpoints can also use the MUTE button.
Page 7 When followed by a paging zone code (0–9 or 0–49), it allows
announcements to be made through endpoint speakers and any external
paging speakers in the page zone.
Page On/Off 325 (Not used on single line endpoints.) Halts pages through the endpoint
speaker or allows them to be received again.
Program Keys 397 (Not used on single line endpoints.) User-programmable feature buttons
and Station Speed Dial buttons can be programmed using this feature
code.
Program Bit Rate
(Feature code appears in
DB Programming but is not
supported.) 393 ( Executive, Professional, Standard, and Associate Display endpoints and
Models 8520 and 8560 endpoints only. ) Allows the user to change the bits
per second (bps) rate of an attached PCDPM serial port. Not supported on
Inter-Tel 5000 platforms.
Program Endpoint Password 392 Programs the endpoint password for the Remote Programming feature.
The password can be changed by entering the Program Endpoint
Password feature code at the endpoint or when using the Remote
Programming feature.
Queue Callback Request 6 Requests or cancels an automatic callback when a busy trunk or endpoint
becomes available.
Record-A-Call 385 If the system is programmed with a Record-A-Call application, the
endpoints can be programmed to use the Record-A-Call feature. It allows
users to enter a feature code whenever they want to record an ongoing
call in their designated Record-A-Call mailbox. Users can retrieve the
recorded messages later, just as they would any other mailbox messages.
Redial 380 Redials the last outside telephone number dialed or saved at the endpoint,
up to 48 digits. Also used to save numbers at endpoints programmed for
last number saved. Inter-Tel endpoints activate with the REDIAL button.
Redirect Call 331 Allows the user to route ringing outside, intercom, and camped on calls to
another endpoint, hunt group, outside number, voice mail, or Do-Not-
Disturb.
Reminder Message
Reminder Message Cancel 305
306 (Not used on single line endpoints.) Sets reminder messages that signal
the endpoint at specific times. Or, cancels all reminder messages for the
endpoint.
Remote Programming 359 Allows a user to place an endpoint in Do-Not-Disturb mode or forward the
endpoint’s calls, either from another endpoint or through DISA.
Reverse Transfer (Call Pick-
Up) 4 Picks up a call ringing or holding at an endpoint or hunt group
Review Keys 396 (Not used on single line endpoints.) User-programmable feature buttons
and Station Speed Dial buttons can be viewed using this feature code.
Ring Intercom Always On/
Off 377 Enables/disables the feature that allows the endpoint to always place
private (non-Handsfree) intercom calls.
Ring Tone Selection 398 (Not used on single line endpoints.) Selects the type of ringing alert tone
that will be heard from the endpoint.
Routing Off 304 Disables System OAI Offering Control for third-party applications. You are
prompted for a password. After you disable routing, you cannot enable it
again (for example, only the third-party application can enable routing).
Station Monitor 321 (Hunt Group supervisors only.) Allows a designated hunt group supervisor
to monitor a call of anyone in the associated hunt group.
Table 6-19. Endpoint Feature Codes (Continued)
Feature Code Description