Mitel Inter-Tel 5000, Руководство по установке и обслуживанию

Страница: 252 / 468

Chapter 5: Installation
Wall-Mounting Model 8500, 8520, and 8560 Digital Endpoints
Page 5-130
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
3. Plug the four-inch line cord into the jack on the back of the endpoint and thread the line
cord through the wall-mount knockout on the base.
4. Test the base to verify that it is securely locked to the endpoint.
5. Insert the two plastic rivets through the metal plate and press them firmly into the holes
on the endpoint base. This locks the metal plate to the base.
6. Re-attach the metal plate to the endpoint base.
7. Plug the line cord into the jack on the wall-mount bracket and position the endpoint
securely on the wall-mount bracket.
8. Flip the handset hanger down to the horizontal position and lock it into place. This will
hold the handset in place.
The following instructions apply to endpoints that have release buttons located on the bottom
endpoint housing. To disengage the locking mechanism in the base, push in both buttons. To
lock the base in position, release the buttons.
To wall-mount Model 8000 Series endpoints with release buttons on bottom housing:
1. Close the base completely so that it lies flat against the endpoint. Rivet hole 1 on the
base aligns with the rivet hole on the bottom housing of the endpoint.
2. Plug the four-inch line cord into the jack on the back of the endpoint and thread the line
cord through the wall-mount knockout on the base.
3. Insert one of the plastic rivets in rivet hole 1 on the base (see illustration above) and
press it into the rivet hole on the endpoint. This locks the base to the endpoint.
4. Test the base to verify that it is securely locked to the endpoint.
5. Re-attach the metal plate to the endpoint base.
Rivet Hole
Base
Rivet Hole 1
Release Buttons
Bottom Housing
(Base not shown)
Rivet Hole 2
(Used to lock metal plate to base)
(Used to lock base to bottom housing)