Mitel Inter-Tel 5000, Руководство по установке и обслуживанию

Страница: 237 / 468

Chapter 5: Installation
Eclipse IP PhonePlus
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
Page 5-115
Eclipse IP PhonePlus
The Eclipse IP PhonePlus is reserved for a future release.
To wall-mount the Eclipse IP PhonePlus:
1. Remove the baseplate from the top half of the back of the endpoint.
2. Rotate the baseplate 180º and attach it to the bottom half of the back of the endpoint.
3. Using a ruler, mark the location of the endpoint mounting holes on the wall. (The centers
of the two perpendicular mounting holes on the back of the endpoint are four inches
apart.)
4. Drive a screw into the center of each mounting hole marking. Allow the head of the
screw to protrude approximately ¼ inch.
5. To hold the handset in place while the
endpoint is wall-mounted, slide the
reversible cradle hook out, rotate it
180º, and reinsert it as shown on the
right.
6. Position the endpoint mounting holes
over the screws and slide the endpoint
into position on the wall. (If necessary,
adjust the screws to ensure the
endpoint is held firmly in place.)
Changing Protocol Modes: ITP and SIP
The Models 8600, 8620/8622, 8662, and 8690 multi-protocol endpoints support Inter-Tel
Protocol (ITP) or Session Initiation Protocol (SIP) mode. Details about each of the modes are
described in the
Specifications chapter. For complete information about supported features,
buttons, and light-emitting diode (LED) indications for multi-protocol endpoints in ITP or SIP
mode, see the
Multi-Protocol Endpoints: Supported Features, Buttons, and LED Indications
document, part no. 835.2840.
To change the modes on Models 8600, 8620/8622, and 8662:
•
Dialpad : To switch to SIP mode , power up the endpoint with and pressed on the
dialpad. To switch back to ITP mode , hold down and on the dialpad while powering
up.
•
Web Interface : Change the operation mode through the Web interface to the endpoint.
•
TFTP Server : Change the configuration files using the TFTP server.
To change the modes on the Model 8690:
Change the operation mode through the Web interface.
IMPORTANT
The preferred method for changing between SIP and ITP mode is
through an Administrative Web Session—see
page 5-572 . If the
endpoint has registered with the SIP Server, resetting the endpoint and
pressing 5 and 6 to change from SIP mode to ITP mode will change
the endpoint to ITP mode; however, Call Processing will not allow the
endpoint to register until the SIP Server relinquishes its connection on
behalf of the endpoint. For details discussed in this procedure, refer to
the
Inter-Tel 5000 Features and Programming Guide (part no:
580.8006)
1 2
5
6