Mitel Inter-Tel 5000, Руководство по установке и обслуживанию

Страница: 234 / 468

Chapter 5: Installation
Model 8600 Series Endpoints
Page 5-112
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
To wall-mount the Model 8600 series endpoints that have a support mechanism:
1. Collapse the support mechanism completely and secure it against the bottom housing of
the endpoint, as shown in the following illustration.
2. Close the base completely so that it lies flat against the endpoint. (The two rivet holes on
the base align with the two rivet holes on the bottom housing of the endpoint.)
3. Plug the four-inch line cord into the jack on the back of the endpoint and thread the line
cord through the wall-mount knockout on the base.
4. Insert the two plastic rivets through the base and press them firmly into the holes on the
bottom housing of the endpoint. This locks the base to the endpoint.
5. Test the base to verify that it is securely locked to the endpoint.
6. Re-attach the metal plate to the endpoint base.
7. Plug the line cord into the jack on the wall-mount bracket and position the endpoint
securely on the wall-mount bracket.
8. Flip the handset hanger down to the horizontal position and lock it into place. This will
hold the handset in place.
The following instructions apply to endpoints that have release buttons located on the bottom
housing of the endpoint. To disengage the locking mechanism in the base, push in both buttons.
To lock the base in position, release the buttons.
Bottom Housing
(Base not shown)
Rivet Holes
Support
Mechanism
Base
Rivet Holes