Mitel Inter-Tel 5000, Руководство по установке и обслуживанию

Страница: 279 / 468

Chapter 5: Installation
Wall-Mounting Mitel IP Endpoints
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
Page 5-157
Wall-Mounting Mitel IP Endpoints
The following procedure provides information on mounting the Mitel IP endpoints on a wall or on
a wall plate. Use
Figure 5-62 as a guide.
Figure 5-62. Mitel IP Endpoint Wall Mounting
To wall-mount the Mitel IP endpoints:
1. Select a location away from electrical cables, pipes or other items that could cause a
hazard when inserting screws in the wall.
2. Turn the base unit so that the hooks on the flat edge of the base unit bend toward the
top edge of the endpoint. Hinge the two upper hooks into the top set of notches and
snap the two lower hooks into the middle set of notches on the back of the endpoint.
3. Secure the base unit using the two screws provided (found in a separate package with
the endpoint).
4. Do one of the following:
•
Mounting on a wall :
Insert two mounting screws 3 1/4 inches (8.25 cm) apart. Allow about 3/16 of an
inch (0.5 cm) between the wall and screw heads for mounting the endpoint. Use
#10 screws 1 to 1.5 inches (2.5 to 4 cm) in length for mounting screws and
anchoring devices suitable for the wall.
•
Mounting on a wall plate :
a.) Plug the endpoint cord into the wall jack.
b.) Place the base unit on the wall plate post, and then push down until the unit is
firmly seated.
5. Using your index finger, lift the clip (from the top) located below the hookswitch, turn the
clip 180 degrees, and then let the clip snap into place to form a hook. The hook keeps
the handset in the cradle when the endpoint is wall mounted.
Endpoint hookswitch clip for vertical mounting
Base unit
CAUTION
Equipment Damage Hazard : Make sure the wall is capable of supporting the weight
of the endpoint. For additional security, mount the endpoint on a plywood backboard.