2
PAD-V
Safety
INSTRUCTION
MANUAL
© MITA Cooling Technologies
S.r.l.
MITA-PAD-V-MAN-IT-
201812
21 / 59
• long and loose sleeves;
• ties and scarves;
• necklaces, bracelets and rings.
• To avoid damaging the
machine and generating dangerous situations, do not to try to hoist
yourself up onto the
machine components.
• Personnel in charge of
machine maintenance must be familiar with the contents of this Manual
and have adequate technical preparation to correctly interpret the instructions and diagrams
attached to this manual and intervene on the machine.
• The area where maintenance operations are carried out (routine and corrective) must always be
clean, dry and with efficient and appropriate equipment available.
• The work area must not be occupied in any way that interferes with the operator's freedom of
movement. In case of an emergency, immediate access to the machine must be guaranteed to
the personnel in charge.
• Access to the aforementioned area is forbidden to people who are not directly in charge of
machine operation in order to prevent hazards due to carelessness or negligence when work is
being performed on the machine.
• If it is necessary to carry out any work near electrical components, keep hands dry and use
dielectric gloves (working on electrical components with wet hands will almost certainly lead to
an electric shock hazard).
CAUTION:
before starting any type of work on the machine or near any of its components, all power
supplies must be cut off; if this is not possible, it is necessary to implement measures that
make it possible to operate safely near the machine.
CAUTION:
tampering with or the unauthorised replacement of one or more machine parts and the use of
accessories, tools and consumables different to those indicated by the Manufacturer can
generate injury hazards.
ENVIRONMENTAL NOTE:
all materials with an environmental impact that must be thrown away following servicing or
work on the machine must be disposed of in accordance with the regulations in force. If
necessary, contact a specialised waste disposal facility.
2.8. Intended use
The PAD-V adiabatic cooler can be used as both a liquid cooler (normally water or a water and glycol mixture)
and as a remote refrigerant gas condenser, in which case the battery must comply with Pressure Equipment
Directive 2014/68/EU concerning pressurised equipment (in this specific case, see also the battery's instruction
manual provided as an annex to this manual.
The operating conditions of the PAD-V, based on the characteristics of the individual model, must always comply
with the technical operating data shown on the CE data plate on board the individual machine. These values
must never be exceeded.
Use of the machine for different operations or in different operating conditions to those given in the technical
operating data shown on the CE data plate could harm people or damage the machine and is therefore
considered improper uses for which the Manufacturer shall not be held liable.
The machine has not been designed and built to be installed in environments with a potentially explosive
atmosphere and/or to treat fluids or gases that are flammable, combustible or electrostatic or which can in some
way generate a potentially explosive atmosphere.
