Minebea Intec X3 Process Indicator PR 5410, Инструкция по эксплуатации инструмента

Страница: 159 / 340

— Service The service window for the load cells is
displayed. No change is possible!
— Limit 1 3 on Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 1 3, clr
(clear) marker 1 3
— Condition Condition, selection: see Chapter 7.17.7 .
— Limit 1 3 off Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 1 3, clr
(clear) marker 1 3
— Condition Condition, selection: see Chapter 7.17.7 .
— Output 1…3 Configure outputs, selection: see
Chapter
7.17.9 .
— Input 1…3 on Configure inputs
— Action Action, selection: see Chapter 7.17.8.1 .
— Condition Condition, selection: see Chapter 7.17.8.2 .
— Input 1…3 off Configure inputs
— Action Action, selection: see Chapter 7.17.8.1 .
— Condition Condition, selection: see Chapter 7.17.8.2 .
— Analog mode Analog output parameter: Gross D08 = gross,
Net if tared D09 = Net if tared, Selected D11 =
value on the display, Transparent D30 =
Transparent, no output = analog output
unused, see Chapter
7.17.10 .
— Analog range Output range: 0 20 mA, <4 20 mA>
— Output on error Output on error: 0 mA = set to 0 mA, <4 mA> =
set to 4 mA, 20 mA = set to 20 mA, hold = last
output value remains unchanged
— Output if <0
7.13.8 Limit parameter
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.13.9 Digital I/O parameters
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.13.10 Analog output parameter
7 Commissioning X3 Process Indicator PR 5410
EN-157 Minebea Intec