Mindray PM-9000, Руководство по эксплуатации

Страница: 301 / 378

CO
2
Monitoring
17-25
„ ALM LEV Alarm level
Options: HIGH, MED and LOW.
„ ALM REC Alarm recording
ON: When a CO
2
alarm occurs, the monitor enables the
recording;
OFF: When a CO
2
alarm occurs, the monitor does not
enable the recording
„ CO2 ALM HI Upper alarm limit of EtCO
2
„ CO2 ALM LO Lower alarm limit of EtCO
2
„ INS ALM HI Upper alarm limit of InsCO
2
„ AWRR ALM HI Upper alarm limit of AwRR
„ AWRR ALM LO Lower alarm limit of AwRR
„ APNEA ALM Determines the apnea alarm delay.
If the apnea of the patient exceeds the preset apnea alarm
delay, the monitor triggers an alarm and gives the " CO2
APNEA " alarm message.
Options: 10S, 15S, 20S, 25S, 30S, 35S and 40S.
„
SWEEP Waveform speed
Options: 6.25, 12.5 and 25.0.
Unit: mm/s.
„ UNIT Options: mmHg and kPa.
„ WAVE SCALE Options: HIGH and LOW.
This option allows you to adjust the amplitude of the CO
2
waveform.
„ WORK MODE Options: MEASURE and STANDBY.
To start the CO
2
monitoring, select the MEASURE mode.
In the STANDBY mode, the air pump and infrared ray
source of the CO
2
module are disabled. Hence, decreases
the power consumption and prolongs the operating life of
infrared ray source and the whole CO
2
module.
NOTE
z
The apnea alarm cannot be disabled.
z
When the CO
2
monitoring is not required, it is recommended the sensor
not be connected and the work mode be set to STANDBY.