Mindray PM-9000, Руководство по эксплуатации

Страница: 214 / 378

SpO
2
Monitoring
12-30
„ AVG TIME Average time
Determines the average SpO
2
calculation time.
Options: 4S, 8S and 16S.
„ NIBP SIMUL ON: When measuring NIBP and SpO
2
at the same side, the
SpO
2
alarm status remains unchanged until the NIBP
measurement is finished;
OFF: The function of NIBP SIMUL is disabled.
„ DEFAULT You can select this option to access the SPO2 DEFAULT
CONFIG menu, in which you may select FACTORY
DEFAULT CONFIG or USER DEFAULT CONFIG. After
finishing your selection and exiting the menu, the system
pops up a dialog box asking for your confirmation.
12.4.6 Accessories
If your monitor is equipped with a Nellcor SpO
2
module, use only Nellcor oximetry
sensors for SpO
2
measurements. Other sensors may cause improper pulse oximeter
performance. Before use, carefully read the directions for the sensor. When selecting
a sensor, consider, the patient’s weight and motion, the adequacy of perfusion, the
available sensor sites, and the required disinfection.
Biocompatibility testing has been conducted on Nellcor sensors in compliance with
ISO 10993-1, Biological Evaluation of Medical Devices, Part 1: Evaluation and
Testing. The sensors have passed the recommended biocompatibility testing and are
therefore in compliance with ISO 10993-1.
Before attempting to clean a SpO
2
sensor, read the directions for use enclosed with
the sensor. Each sensor model has cleaning instructions specific to that sensor.
WARNING
z
Incorrect use of an oximetry sensor may cause damage to the patient’s
muscle. Verify the sensor site carefully according to the directions for
use.