MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 130 / 174

Chapter 7 Operation, Adjustment, and Maintenance
7-10
Belt Cleaning Procedure
If you need to remove the adhesive after using the printer, follow the procedure below.
Cleaning
The print head station is on the carriage of the print head inside the printer structure.
When the carriage is in the rest position, the station contacts the printhead. At this location, the print head performs ink
purge, after which the extra ink is removed and the print head is in the proper state due to the forward and backward
movement of the station.
In the periphery of each head groove, there is a wiper that can remove ink from the print head.
Ink inside the unit is discharged from the station using an appropriate discharger (one for each unit) connected to the main
drain of the machine.
The drain pipe of each head groove is in the raised position. There is always an ink layer for dampening the head with this
method, but when the head groove is full, it is discharged to the bottom of the head groove through the discharge hole.
Cleaning is done to remove ink droplets from the head that affect printing on the media.
Procedure Belt cleaning procedure
S Mode Key Indication Operation Reference
1
Remove the washing tank so that the solvent used for
cleaning will not damage the belt.
9-3
2 Protect print heads and cylinders
3
While transferring the belt (such as applying the
adhesive), apply the solvent type Persolvan NV evenly
over the entire surface of the belt and remove excess
adhesive with one or more cloths.
4
It is recommended to use a nebuliser for the solvent
application.
5
Once all the residue is removed, you can apply a new
layer of adhesive.
End of procedure
Print head station
Head groove
Discharge
hole