MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 150 / 174

Chapter 9 MAINTENANCE
9-6
F432 1 or 2
DRYERJET
Winder big
diameter Alarm
The diameter of the
wound media on the
DRYERJET is too
large.
1. Check the diameter of the wound media.
The maximum diameter is φ 500mm.
If the diameter is over 500mm, replace the roll.
2. If the dancing bar is lowered too much during a jog or
feed and the media is slack, readjust it so that it does
not slack.
3. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
4. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
5. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F437 2
DRYERJET
Communication
Alarm Communication error
between DRYERJET
and the machine 1. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
2. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
3. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
F440 2
Purge not started
Alarm
PLC Parameter Error
F445 1 Current heater MIN
Belt heater current
error (Lower than the
set lower limit)
F446 2
Current heater
MAX
Belt heater current
error (Higher than the
set upper limit)
F452 3 Belt generic Fault Belt control error
F453 3
Carriage generic
Fault
Carriage control error
F454 3
Carriage
thermoswitch
Alarm
Linear motor error
F456 3 Emergency ON
Emergency switch or
area sensor error
1. Check the following items.
(1) Are all 4 emergency switches on the machine
released?
(2) Are the machine covers (6 places) completely
closed?
(3) Whether the maintenance cover is completely
closed.
(4) Whether there is something shading the area
sensor.
(5) Are all emergency switches on the DRYERJET or
feeding unit released?
(6) Check if all of Dryerjet or Feeding unit doors are
closed.
2. Press the emergency reset switch.
3. Tap the [DETAIL] button in [SYSTEM ALARM], and
tap the [CLEAR ALARM] button.
4. If the alarm appears again even after tapping the
[Alarm Clear] button, turn off the power of the built-in
PC and then the printer. After a while, turn on the
power of the printer and then the PC.
5. If the Alarm appears again, contact your local
distributor, our sales office, or service center.
Error
No.
Error
level
Error displayed Cause Measures