MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 125 / 174

Chapter 7 Operation, Adjustment, and Maintenance
7-5
7
2
3
4
5
6
Procedure for Cleaning and Adhesive Application
When the adhesive is applied evenly to the belt, adhesiveness and stability of the media are ensured. This is an essential
task to get the proper performance of the printer.
After a certain period of time, depending on the printing conditions, you can check whether the effectiveness of the
adhesive is not falling.
In the event of ineffectiveness, it is necessary to completely remove the adhesive and then re-apply the new adhesive.
Preparation of Belt Cleaning Unit
The machine is equipped with two rotating brushed belts.
To operate the belt cleaning unit, follow the procedure below.
• Cleaning agents used for cleaning and adhesive for application include toxic and flammable substances.
• We recommend that you follow all safety instructions supplied by the supplier carefully.
• Mimaki is not responsible for the results of not following these guidelines.
Procedure Preparation of belt cleaning unit
S Mode Key Indication Operation Reference
1
Make sure that the discharge valve is closed and that
there is no dust or dirt in the tank.
2
Change the operation time (frequency and function
time) of the solenoid valve using a command from the
computer, or directly fill the tank with water to the
discharge level.
3
In case of directly filling water, it is necessary to take
out the tank according to the procedure described in
this manual.
9-3
4 AUT
When the water reaches the maximum level, it is
automatically discharged to the main drain of the
plant.
5
If you need to thoroughly clean the tank, open the
exhaust exclusion valve. and empty it.
6
Perform internal cleaning of the tank to remove
residual ink, dust and dirt.
7 Close the exhaust exclusion valve.
8
Put clean water manually or using a solenoid valve
from the PC.
End of procedure